Reply to thread

Message: <blockquote data-quote="WillieFlo" data-source="post: 6618" data-attributes="member: 10178">OK, so I was trying to install FMI Half Billet Tie Rods and noticed I had a 24mm open end wrench for the support sleeve(Silver in photo), but did not have big enough wrenches for thelarge jam nut & tie rod(CIRCLED IN PHOTO) on the wheel end of the rod.I went to the local AZ and O'Reilly's, but the largest wrench I could find in Metric was a 27mm, which was too small, and SAE sizes were not correct either.Anyone know what wrench size I need to order online to get these installed myself???(I reached out to Foutz MS via email, and waiting for a response from them as well. Will share results if I receive from them first.)[ATTACH=full]3008[/ATTACH]Just FYI: I have these on my Gen 2 Raptor with 37's and I will tell you they are worth the money! Really beef it up if you off-road much. I had them installed by someone else during a build phase and don't know what wrench they used.Thanks for any help.</blockquote>